rbootseq.1¶
SYNOPSIS¶
rbootseq [-h | --help | -v | --version]
Blade specific:¶
rbootseq noderange {hd0 | hd1 | hd2 | hd3 | net | iscsi | iscsicrit | cdrom | usbflash | floppy | none | list | stat},...
HP Blade specific:¶
rbootseq noderange {hd | net1 | net2 | net3 | net4 | cdrom | usbflash | floppy | none},...
PPC (using Direct FSP Management) specific:¶
rbootseq noderange [hfi|net]
DESCRIPTION¶
For Blade specific:
rbootseq sets the boot sequence (the order in which boot devices should be tried) for the specified blades. Up to four different medium/devices can be listed, separated by commas. The boot sequence will remain in effect for these blades until set differently.
For PPC (using Direct FSP Management) specific:
rbootseq sets the ethernet (net) or hfi device as the first boot device for the specified PPC LPARs. The rbootseq command requires that the ethernet or hfi mac address is stored in the mac table, and that the network information is correct in the networks table.
OPTIONS¶
hd0 | harddisk0 | hd | harddisk
The first hard disk.
hd1 | harddisk1
The second hard disk.
hd2 | harddisk2
The third hard disk.
hd3 | harddisk3
The fourth hard disk.
n | net | network
Boot over the ethernet network, using a PXE or BOOTP broadcast.
n | net | network | net1 | nic1 (HP Blade Only)
Boot over the first ethernet network, using a PXE or BOOTP broadcast.
net2 | nic2 (HP Blade Only)
Boot over the second ethernet network, using a PXE or BOOTP broadcast.
net3 | nic3 (HP Blade Only)
Boot over the third ethernet network, using a PXE or BOOTP broadcast.
net3 | nic3 (HP Blade Only)
Boot over the fourth ethernet network, using a PXE or BOOTP broadcast.
hfi
Boot p775 nodes over the HFI network, using BOOTP broadcast.
iscsi
Boot to an iSCSI disk over the network.
iscsicrit
??
cd | cdrom
The CD or DVD drive.
usbflash | usb | flash
A USB flash drive.
floppy
The floppy drive.
none
If it gets to this part of the sequence, do not boot. Can not be specified 1st, or before any real boot devices.
list | stat
Display the current boot sequence.
EXAMPLES¶
Set blades 14-56 and 70-203 to try to boot first from the CD drive, then the floppy drive, then the network, and finally from the 1st hard disk:
rbootseq blade[14-56],blade[70-203] c,f,n,hd0
SEE ALSO¶
rsetboot(1)|rsetboot.1